Tutorial 4 : Using Serial Communication on LaunchPad
This tutorial is about how to enable and properly configure UART on your Stellaris LaunchPad. This tutorial is the first of its kind and is exclusively meant for teaching how to write into a serial stream, how to set the baud rate parity bit, stop bit etc. These tutorials may at the first look seems useless but I only mean to teach you the basic concepts of how to program the ARM based microcontroller. Therefore these can be used to implement small small subsystems in your project. Before going to the detailed analysis please go through the code which i have provided. I think that once you have went through the previous tutorial, you must be able to understand the tutorial even without checking the line by line explanations.